Kba 105 pression problem

[Marco]

“I have a problem with my KBA 105 printing machine from 2000. After relocating the machine to a new facility, I’m experiencing a strange issue: the printing units are not applying pressure correctly. As a result, the first sheet comes out only half printed, as shown in the attached photo.
Can anyone help me understand why this is happening, since KBA is not providing support?”

 

[Koenig]

“I have a problem with my KBA 105 printing machine from 2000. After relocating the machine to a new facility, I’m experiencing a strange issue: the printing units are not applying pressure correctly. As a result, the first sheet comes out only half printed, as shown in the attached photo.
Can anyone help me understand why this is happening, since KBA is not providing support?”

Dear Marco,
Dont worry if KBA is not of any HELP, i can help for KBA machines very well.
If you still have the problem, please rechecek:
As you have reinstalled the machine, its quite possible that the machine angle settings are disturbed, you know all the printing machines take the commands from the machine degree (you can have a look at the machine display), recheck the machine's mechanical postion (ZERO Position) and Electrical zero position, they must be same.
Since these are very sensitive information, I cant put them on a public forum, because the worng position can cause an accident. To help you further get back to me, and I can guide you tó fix the issue with step by step guide.