ink fountains not moving

Discussion in 'DI Presses' started by kristianeyman, Nov 30, 2015.

  1. kristianeyman

    kristianeyman Senior Member

    Joined:
    Jan 2011
    Messages:
    76
    Location:
    mexico
    good afternoon,

    i am having a problem where none of the four ink fountains are moving or responding to a change in stroke when put into the GUI. i have swapped out MOT/TSK/MWE boards and no luck!? i have also loosened the worm gear, and then the pensiometer does respond to the GUI commands....but once tightening the worm gear again, no dice!?
     
  2. augustov

    augustov Senior Member

    Joined:
    Aug 2011
    Messages:
    171
    Location:
    Colombia
    Make sure that BIOS setup is correctly, make that serial port COM1 is disable, COM1 is for GSM module; COM3 is for comunication with STK (Press ready and status).; COM1X is for EAM module (Plus qmdi). Check for data cable and make sure that is good. Look for the fuse in GSM module. Look for power is good. Check the sumary for MSDOS with starting with F8 holded (Safe mode). Any problem add me to whatsapp +57 3016958869
     
  3. kristianeyman

    kristianeyman Senior Member

    Joined:
    Jan 2011
    Messages:
    76
    Location:
    mexico
    ended up being the MWE....swapped it out from my plus, but the extra board i have must be bad!?
     
  4. augustov

    augustov Senior Member

    Joined:
    Aug 2011
    Messages:
    171
    Location:
    Colombia
    What do you mean by extra board? the EAM card? Write to my whatsapp...
     

  5. kristianeyman

    kristianeyman Senior Member

    Joined:
    Jan 2011
    Messages:
    76
    Location:
    mexico
    augustov,

    it was the MWE board...i have two presses, and extra boards parts etc....

    add me to your whatsapp 52 222 451 8858
     
Loading...