Mahendra Phadke
New Member
- Joined
- 2018
- Posts
- 1
- Geo
- Mumbai
Ink and Water Damping stuck
- Thread starter Mahendra Phadke
- Start date
CHOCK
Senior Member
- Joined
- 2016
- Posts
- 3,125
- Geo
- Managua,Nicaragua
Hi sir :
Please see the status LED's for Units in te Board(s): LTK 50 ;
a) Normal condition the Led goes out when motor is running and light up when is standby.
b)If malfunction appear: 1) No enabling HAK 2) overcurrent motor 3)fuses B1+B2 bLOWN Test it.
LTK500:
Yellow led:
a) Normal condition the Led goes out when motor is running and light up when is standby.
b) Malfunction on the LT oron the motor one or both diode light up
Red Led:
a) Not enabling LT
b) overcurrent or overvoltage U <80V or >140v LT switch Off temporarily.
c) U <70v or 180v Switch off completely.
Reset or Fuses Blown (burning protection)
Not enabling of the HAK
Please see the status LED's for Units in te Board(s): LTK 50 ;
a) Normal condition the Led goes out when motor is running and light up when is standby.
b)If malfunction appear: 1) No enabling HAK 2) overcurrent motor 3)fuses B1+B2 bLOWN Test it.
LTK500:
Yellow led:
a) Normal condition the Led goes out when motor is running and light up when is standby.
b) Malfunction on the LT oron the motor one or both diode light up
Red Led:
a) Not enabling LT
b) overcurrent or overvoltage U <80V or >140v LT switch Off temporarily.
c) U <70v or 180v Switch off completely.
Reset or Fuses Blown (burning protection)
Not enabling of the HAK
Advertisement:
Forum posts represent the experience, opinion, and view of individual users. The Color Printing Forum does not necessarily endorse nor share the view of each individual post.
When making any potentially dangerous or financial decision, always employ and consult appropriate professionals. Your circumstances or experience may be different.
Similar threads
