Ideal 4850 - ER 10 - Wonky Motor and No Longer Calibrated

[ROBERT MINTON]

So I had a service call and my tech was unable to recalibrate my cutter.

he was able to bend the screw for backgauge so it hit further, but when trying to recalibrate by using measurements and the keypad to reset it, just wasn't working.

was told I need to replace the keypad and board.

was hoping someone here had any experience and or could tell me which parts I do need to replace and how I would go about getting them.

thanks so much.

 

[CHOCK]

Hi Robert:
Will be a good ide to replace the keypad and board, for to avoid error.

You can order from:



2622 W Maplewood Ave, Bellingham, WA, United States, Washington

+1 360-647-2828

Michellej@mbmtoshiba.com

mbmtoshiba.com