Hydraulic oil - Polar 80 EL

Discussion in 'Heidelberg Printing Presses' started by Andres Feria Gutierrez, Jun 11, 2019.

  1. Andres Feria Gutierrez

    Andres Feria Gutierrez Member

    Joined:
    May 2019
    Messages:
    7
    Location:
    Colombia
    hello Everybody,

    I was wondering if someone has changed the hydraulic oil for a Polar 80 EL. I have two doubs about it:
    1. What hydraulic oil can I use?
    2. I attached a picture where there are the holes that I think are used for this porpuse. is the upper hole the drain hole and the lower one the filling hole?

    I really appreciate any information
     

    Attached Files:

  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi sir:
    Attached is there the Oil hydraulic for your machine 80 EL.
    1) you can use the alternatives Oil hydraulic available.
    2) The section in Red upper hole : is for to bleeding the Hydraulic Clamp. since your machine the knife is Electromagnetic clutch, No bleeding need it. you must do it, until all the air is out from the system.
     

    Attached Files:

  3. Andres Feria Gutierrez

    Andres Feria Gutierrez Member

    Joined:
    May 2019
    Messages:
    7
    Location:
    Colombia

    thank you very much for your prompt reply to my question
     
Loading...