help! error code 15-04

Who know how much is the resistance?

 

570 ohm, but take a stronger one 2W at least.
It has nothing to do with 15-04 error.
It controls the high speed of Ametek blower.
rgds
Jan

 

I fix the problem about the burn....but when I turn my press on, It show me error code (15-04)

Please help me.

 

Thank You for tell me that, But the error code still come 15-04. What can I do for this error?

 

Error code 15-04 is in the safety circuit. Have you checked your SVK3 board.

 

Is 15-04 a single one error?
Normally it comes together with 15-01. You can read about it in today post from Paul concerning 15-01 error,
so check all 4 magnetics in the doors.
Once I had both those errors, because of emergency switch connector not properly insert.
Check also the place where your 470 ohm resistor was burned, if there are any damages of isolation there.
rgds
Jan

 

check all 4 magnetics in the doors. I found it, thank you!