Hamada 800dx or 700 Operators Manual

Discussion in '1-Color and 2-Color Offset Presses' started by Anocoil, Jun 4, 2013.

  1. Anocoil

    Anocoil New Member

    Joined:
    Jun 2013
    Messages:
    4
    Location:
    CT, United States
    Anyone have a readable Hamada 800 Operators manual? I sure a 600-700 one will be close enough. We have on in our R&D department and they want me to set it up.
     
  2. FFR428

    FFR428 Senior Member

    Joined:
    Feb 2008
    Messages:
    438
    Location:
    CT
    Where are you in CT? The 800 has a pull guide and the 700 that $#itty suction pull guide. How bad is the press?
     
  3. Anocoil

    Anocoil New Member

    Joined:
    Jun 2013
    Messages:
    4
    Location:
    CT, United States
    Anocoils R&D is in Enfield, CT. We are a plate manufacturer.
    The 800 we have runs, just looking for a user manual for it. I am not familiar with making adjustments on a small press. Use to run Heidelberg V15's and Community Goss 20+ years ago...
     
  4. FFR428

    FFR428 Senior Member

    Joined:
    Feb 2008
    Messages:
    438
    Location:
    CT
    http://www.allarsen.com

    ^^^ Try A.L. Larsen. They were the local east coast Hamada dealer before Hamada went out of bizz. I'm sure they can help you. If not let me know and I'll try to locate one. I'm down by the CT/NY line or I'd stop by and have a look. The 2 water forms can be a PIA and the pull guide is not a very good design. Other than that not a bad press. A lot like the old Multi W's sorta.
     
  5. Anocoil

    Anocoil New Member

    Joined:
    Jun 2013
    Messages:
    4
    Location:
    CT, United States
    I dont need anyone to look at it, just looking for a operations manual.
     
  6. FFR428

    FFR428 Senior Member

    Joined:
    Feb 2008
    Messages:
    438
    Location:
    CT
    Try Larsen for the manual. That's why i put the link there. If they don't have one I know a ST who might.
     

  7. superteto

    superteto Previous User

    Joined:
    Feb 2014
    Messages:
    48
    Location:
    no
Loading...