Guillotine cutter out of skew.

Discussion in 'Cutters and Trimmers' started by JenniferJ, Jan 26, 2018.

  1. JenniferJ

    JenniferJ New Member

    Joined:
    Jan 2018
    Messages:
    1
    Location:
    Iowa
    My Ideal 4700 is out of skew - pretty sure it's the stopper plate but service tech says it's as good as he can get. Is there any reason why I shouldn't cut and then flip the stack and cut again to true it up? It's been a long time since I've done lots of cutting but I can't think of why that won't work.
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Hi sir
    Good day
    This guillotine as any equipment has a time , that need to repair or adjustment or exchange , some parts coming to wear way,
    must be check:1) Knife carrier 2)guiding plates 3)knife depth ajustment and proceed according.
    Look for LUBE very well., i strong recommend you look for some tech and experience in troubleshooting paper cutter.
     
  3. valeri

    valeri New Member

    Joined:
    Feb 2018
    Messages:
    2
    Location:
    г. Тбилиси
    Мне нужна Ваша помощь
    У меня гелиотина с экраном POLAR MOHR 115 EMC - MONITOR Mach № 6031733.Мне нужна электрическая схема и совет как определить дефект . на экране пишется REFERENZ-MASS ANFAHREN и машина перестаёт резать бумагу в установленном режиме размеров
     
  4. valeri

    valeri New Member

    Joined:
    Feb 2018
    Messages:
    2
    Location:
    г. Тбилиси
    Ответ прошу напрвить по адресу valer51@mail.ru. заранее благодарен
     

  5. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Good day Mr Valeri:
    Hope you are well.
    Please test limit switch S22a+S22b or
    if you sistem use the Knife upstroke with sensor, test the sensor for prevent
    Non repeat device.
     
Loading...