Ghost Jam area 3.

[peels]

Igen 4.

There was NEVER a jam there, it was sitting idle.... Now, error is there, and will not clear. I've cleaned every sensor (i can see)

am I missing something?

 

[richman]

Is the sensor aligned with its reflector?
Is there a transport belt covering it? (Had that happen once)
Try pushing the sensor with your finger to move it and see if it clears.

Otherwise, I'd replace the sensor.

 

[peels]

Bravo!

well done sir! area 3 sensor on the vacuum transport....pushed to left and "popped" over into place.. error cleared. Had to push pretty hard...I didnt feel comfortable doing it...but had nothing to lose

I had just done that came on to post.

it's a good thing too, my mech is on vaca... and I need the Igen tomorrow. I was diggin through bags of sensors LOL

 

[richman]

Woo hoo! Nice