Feeder air pressure

took on a big responsibility running a multi drawer job. It is 1 sheet offset, followed by two address LABELS. 14x17 to the tune of 170,000. but simplex at least!


these labels, true to form, are killing me. sometimes run great, others not at all. heavy, flimsy, curly. troubles keepin stack height at a good level. Set high altitude in stacker NVM's thats workin out well!

I have a LOT to do, so... I would like to add a little pressure to the blower for vacuum and air knife...Id like to do this correctly. not the usual "yo what dis button do?" LOL

which NVM's are correct...? anyone ever do this?

 

OK just did it my way lol runs decent until theres sheets with too much glue and theyre sticky....
NVM id's for future reference:


nvm 11466 upper blower motor override speed disable. uncheck.
nvm 11390 upper blower motor override speed(set mine to 1700 for this...was at 1100, max is 2000) it's obviously louder but works for this garbage paper!