Geordi
New Member
- Joined
- 2026
- Posts
- 1
- Geo
- Jamaica
Hey everyone,
Looking for some troubleshooting steps for getting our PC controller software working after a rebuild, we have a DSC 10/60 Collator, A DBMS-T, A DBMS-S and a DKT-200 connected over D-Link only, The issue we have is that once the program starts the Protocol Module.exe crashes with the error code fault offset 0x0000ce7a, So far we tried disabling Data Execution protection and disabled driver signature enforcement we also tried installing it on Windows 10, Windows 8.1 Windows 7 and Windows xp but we get the same error, Any help would be appreciated.
Looking for some troubleshooting steps for getting our PC controller software working after a rebuild, we have a DSC 10/60 Collator, A DBMS-T, A DBMS-S and a DKT-200 connected over D-Link only, The issue we have is that once the program starts the Protocol Module.exe crashes with the error code fault offset 0x0000ce7a, So far we tried disabling Data Execution protection and disabled driver signature enforcement we also tried installing it on Windows 10, Windows 8.1 Windows 7 and Windows xp but we get the same error, Any help would be appreciated.