DPM 2340 Engine Error

Discussion in 'Platemaking' started by VAprinter, Feb 13, 2013.

  1. VAprinter

    VAprinter Member

    Joined:
    Mar 2010
    Messages:
    9
    Location:
    Virginia
    Receiving Imagesetter general error. 2211 No spinner encoder signal. I cycled power and unloaded plate material. Now DPM will not even load plates. Has anyone had similar problem? Results?
     
  2. muske99

    muske99 Member

    Joined:
    Apr 2014
    Messages:
    5
    Location:
    Illinois USA
    I see this is an old post - I was getting error issues ( nothing would work ) and found the spinner was not spinning - on the left side attached to the motor is a break away assembly - that broke away - couple drops of crazy glue and back in business - just curious what you found
     
  3. VAprinter

    VAprinter Member

    Joined:
    Mar 2010
    Messages:
    9
    Location:
    Virginia
    The circuit board that supplies and distributes the power went bad. Had to replace the whole board. It took a very long time to diagnose and correct the problem.
     
Loading...