Curious metalic cover

[spike]

HELLO ALL i have an upcoming project on curious metalic stocks i intend
to use 100% solids ink and an overall varnish iwas wondering if anybody
in this forum has used this stock and how were your results thanks for any
advice. spike

 

[jetscreamer]

Spike I print on this stock here in in Australia, I treat it like any other stocks except I would run smaller stacks and a inline varnish. Also give it an extra day to cure.
cheers
jet screamer

 

[spike]

hello jetscreamer thanks for the reply i ran job on friday coverage was light the stock was apleasure to
work with i did not need to varnish just kept .water to a minimum and ir low ran lots of powder .