CPC1.02 problem stuck at open

Discussion in 'Heidelberg Printing Presses' started by jenniferbtheberge13, May 27, 2018.

  1. jenniferbtheberge13

    jenniferbtheberge13 New Member

    Joined:
    May 2018
    Messages:
    1
    Location:
    TP HCM
    My SM102 cannot go inside the system. When I turn om the machine , Cp tronic screen just hang up and appear text " Heidelberg" cannot go inside just stuck at there. Can anybody help to solve the problem? Thanks before.
     
  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    861
    Location:
    Managua
    Hi Jenniferbtheberg:
    Hope you are well.
    Follow this Steps for Troubleshooting:
    1) take visual inspection, use the Human Mind the best Invaluable Tool: look if Circuit breaker are tripped or blown fuse in the section power supply Nte, use the schematic diagrams.
    2) turn off machine in #1 , and Reseating boards and components. Edge is common source of problem, look for loose and broken wires. Improperly seated connectors, loose, broken wires, missing jumpers.check for obviously damaged components ( burned or discolored to due overheating )
    3)Clean Edge connectors w contacts electronic Spray . Then turn on Cpc and test see what did happen.
    Let me know.
    Blessing
    superchock@yandex.com
    celular+WhatsApp:+50588611441
     
Loading...

Share This Page