CP 2000

Discussion in '4-Color Offset Presses +' started by fernando_f, Sep 25, 2024.

  1. fernando_f

    fernando_f Member

    Joined:
    Aug 2019
    Messages:
    5
    Location:
    Portugal
    Hello, good afternoon, Can someone help me?
    I have a problem with Windows startup. After turning on the machine, it reaches this point, and the screen turns blue, staying stuck on this page. It doesn't go any further. We've switched to the second disk to try and recover, but the same thing happens... We've also accessed through the BIOS, and the exact same thing happens.
    Thank you.
     

    Attached Files:

  2. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    3,017
    Location:
    Managua,Nicaragua
    Hi, sir;

    Please take out the RAMS, and clean with eraser pencil, and then spray with contact cleaner , males,and females contacts, carefully.

    The same clean clean carefully the EPROM, from dust, and invisible oxide, .take out, and do it the same, with the pins... Males and females.


     
  3. Adil

    Adil Senior Member

    Joined:
    Nov 2021
    Messages:
    1,123
    Location:
    Casablanca
    Hi sir .
    Switch to the hdd2 and run wait for scan then return to the first hdd1 .
    If this solution can not solve the issue i will send you both hard disk reach me on whatsapp +212700552467
     
  4. fernando_f

    fernando_f Member

    Joined:
    Aug 2019
    Messages:
    5
    Location:
    Portugal
    Good morning, everyone! I would like to thank you all for your help. In the end, the solution was to replace the two damaged disks and reinstall the program, which resolved the issue. The disks were damaged due to power outages caused by the wildfires near the company. Thank you again for the support.
     

  5. Adil

    Adil Senior Member

    Joined:
    Nov 2021
    Messages:
    1,123
    Location:
    Casablanca
    Good job ,
     
Loading...