Calibrating of EDGE DETECTION Sensor in LOTEM QUANTUM.

Dear Lotem Quantum users,

As you can see in the attached photo,I have problem of registration in the CMYK plates
due to the EDGE DETECTION SYSTEM which is adopted by KODAK, meaning the plates are aligned by reading the emulsion
on the plate's edge.
It happens when I'm using plates from China or Taiwan which are not confirmed by Kodak...

Is there any CALIBRATION possibilities to adjust the sensitivity of the Edge Detection Sensor?

Your help will be appreciated,

Zamir Bar-Lev

email: zamir@printiv.net
Printiv Press
Jerusalem, ISRAEL