Any R200H OB series 257 year 1993 specialist?

I need to put electrical (angle encoder) and mechanical machine zero adjustment please. If you have documentation of this very old machine also could be good. Thanks!

Errors 99-10 (see next picture) on leuze panel control is also showed after run the machine, do you have any idea or error list please?

 

Take:
It is important to observe the position of the transport grabs when installing this machine. 1 to 2 (adjustable to non-adjustable)

 

Thanks for your answer, you meant about this:

9.9 Insert carrier carriaqes - Insert gripper carriages 1 to 8 into press in proper sequence and in machine running direction FORWARD..... etc etc (page 123?) Ok Ill check by a mehanic.

Please Another question:

- I found swipped the Input boards 47 and 55 at U1 rack. And i dont know if the technician who made this, keept the same jumper configuration or they swipped also. One of This boards controls the angle encoder and other signals like infeed sensors. Can you tell me the correct position of them please? See next picture attached.

Thanks

 

Different jumpers mean different functions. The position of each board and the position of the jumpers is described exactly in the documentation of the specific machine. Unfortunately, I do not have complete documentation of this old machine.

 

Oh i see. Then if the jumpers are wrong could cause these errors?

 

The automatic functions of the machine will not work properly and maybe the machine will not run.
Jumpers can be copied from another machine.