AGFA Xcalibur 45 error list and explanations

Discussion in 'Platemaking' started by evve, Feb 12, 2010.

  1. evve

    evve New Member

    Joined:
    Feb 2010
    Messages:
    2
    Location:
    Kyrgyzstan
    Hi guys,

    I'm looking for AGFA Xcalibur 45 error list and explanation of solving that error.

    I have some problems in CTP

    Thanks for everybody :cool:
     
  2. Armya

    Armya New Member

    Joined:
    Mar 2010
    Messages:
    1
    Location:
    Canada
    Need help with your Xcalibure 45?

    Hi error list doesn't lead you to a solution with X45.

    Please contact me. I can help you
     
  3. evve

    evve New Member

    Joined:
    Feb 2010
    Messages:
    2
    Location:
    Kyrgyzstan
    Not only X45

    Good day,

    The error code list helps to determine waht exactly the problem is.
    Besides, at the moment the top problem is in a chiller. The chiller pump is damaged. I will recieve the new one next week. After chiller is fixed, I have to solve the problem in the pneumatic system of X45.

    I will thank you if you inform me needed information to fix the system.

    Kind regards
     
  4. Nabil Ahmed

    Nabil Ahmed New Member

    Joined:
    Mar 2018
    Messages:
    2
    Location:
    Egypt
    Hi
    i have error A0622
    fixed clamp failed to disengage
    in unidiag -- tools-- Xcalibur 45 tools --control-- initialize
    error
    the command "Initialize" failed with following error code :"command failed"
    and in LogMMM
    error :h410c2111
    any one can help me please?
     
  5. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    988
    Location:
    Managua,Nicaragua
    Hi sir
    Good day, hope you are well
    Here the error what does mean it:
    A0622 Media Handling Failure * : Remove plate from input slot or exit tray,
    conveyor – fixed clamp failed to disengage.
    Hope you fix it.
    Let me know any question.
    Blessing
    superchock@yandex.com
    cell+whatsApp:+50588611441
     
  6. Nabil Ahmed

    Nabil Ahmed New Member

    Joined:
    Mar 2018
    Messages:
    2
    Location:
    Egypt
    i read that in service manual
    but i have not plate in input slot or exit tray
     

  7. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    988
    Location:
    Managua,Nicaragua
    Hi sir
    ok test the sensors +calibrate the machine in section Diagnostic
    and proceed.
    Blessing
    superchock@yandex.com
    cell+whatsApp:+50588611441
     
Loading...

Share This Page