agfa lithostar lp82 problems

Discussion in 'Platemaking' started by NimeshSilva, Aug 18, 2015.

  1. NimeshSilva

    NimeshSilva Senior Member

    Joined:
    Jan 2013
    Messages:
    226
    Location:
    Sri Lanka
    Hi all,
    I'd be very grateful if somebody has the service manual and electrical diagram for agfa lithostar lp82 plate processor. we got some problems with it and need to be corrected very soon.

    Thanks in advance.
     
  2. Guy L.

    Guy L. New Member

    Joined:
    Jan 2018
    Messages:
    2
    Location:
    Virginia, USA
    Hi Nimesh
    Agfa Lithostar LP82 Plate Processor. We are experiencing an electrical problem with the drive of the processor. Do you happened to have a service manual or electrical diagram?
    Thank you very much.
     
  3. Guy L.

    Guy L. New Member

    Joined:
    Jan 2018
    Messages:
    2
    Location:
    Virginia, USA
    By the way, the error code that I am getting is: M12: 3
     
  4. HP INDIGO CARE

    HP INDIGO CARE Member

    Joined:
    Jul 2017
    Messages:
    11
    Location:
    UAE
  5. HP INDIGO CARE

    HP INDIGO CARE Member

    Joined:
    Jul 2017
    Messages:
    11
    Location:
    UAE
    Check wiring between RS485 on Gateway board
    (U7) and Controller (U6).

    Check motor M12 (Transport Motor) Clean the connections and check the drive belt is working fine without any overload.

    Action
    1 Switch off the processor and restart after 10 sec.
    2 Measure current towards the motor (0.5 — 0.6 A / phase).
     
  6. Carel

    Carel New Member

    Joined:
    Apr 2019
    Messages:
    3
    Location:
    Strand, Western Cape, South Africq
    Hi, We use a AGFA Palladio LP82 Ultra. Weve been informed that AGFA will discontinue providing the plates. Any idea of where else one will be able to purchase? Im in South Africa. Carel@gableprinters.co.za
     
  7. Vic the Printer

    Vic the Printer Member

    Joined:
    Aug 2008
    Messages:
    62
    Location:
    United States
    I too have the same setup and was just told the same thing.. have You been able to find out more info?
     
  8. Carel

    Carel New Member

    Joined:
    Apr 2019
    Messages:
    3
    Location:
    Strand, Western Cape, South Africq
    We had until Yesterday to order plates. Ive tried to find out if one can get plates elsewhere but have not been succesful. Let me know if you find any? Im from South Africa. You can also send me an email to carel@gableprinters.co.za
     
  9. HP INDIGO CARE

    HP INDIGO CARE Member

    Joined:
    Jul 2017
    Messages:
    11
    Location:
    UAE
    Already given quotes to you well in advance. After that no response from your side. We can supply LAP-V Plates, but you should ensure the minimum volume as provided in the quote.

     

  10. Carel

    Carel New Member

    Joined:
    Apr 2019
    Messages:
    3
    Location:
    Strand, Western Cape, South Africq
    Hi, We do around 200 to 300 plates a months so your minimum is not feasible for us. Thanks Carel
     
Loading...