Agfa Acento IIS - Moving

Discussion in 'Platemaking' started by KOBYN, Aug 29, 2019.

  1. KOBYN

    KOBYN New Member

    Aug 2019
    Moncton, NB
    We need to move our Agfa Acento IIS and we have all the original locking tabs, plates and screws. Agfa won't give us any info, but we're looking for a diagram of where these locking plates are to be installed. We have figured out most of them, but it seems that the drum needs to be locked via a servo motor, must not sure if I'm correct or there is a command on the interface.