AGFA 45E Azura - Error

Hello all,

Thanks in advance for any help on this issue.

When imaging plates ... the plates are not dropping into the lead clamp on the drum all the way... The plates feeds in stops, the leftside drops down into the head clamp and the rightside gets into the clamp however not all the way. The plates end up with a crooked image that is skewed by 1/4 of an inch.

Does anyone have any ideas what maybe going on? Any suggestions would be helpful at this point

Thanks again all !!!

 

We were able to get the issue fixed. The infeed roller that holds the plate aginst the drum had moved back away from the drum by 1mm. This 1mm gap was enough to not allow the plate to fall correctly into the lead clamp. we readjusted the roller plate and so far all seems well.

Thanks guys, this is the best forum community by far, that I have run across.