aftermarket Mitsubishi coater

Discussion in 'Mitsubishi Printing Presses' started by iambear, Sep 9, 2015.

  1. iambear

    iambear New Member

    Joined:
    May 2012
    Messages:
    2
    Location:
    Ontario Canada
    blanket flew off during a run and went in between last unit blanket and plate cylinder.. now that's all fixed up and I need to do all settings again. problem setting the anilox roller to the blanket. hit stripe test in make ready mode with unit up and then the roller stops spinning but nothing happens? let go of button then ithe roller starts to turn again
    need help as they want this up and running fast

    thank you
    Barry
     
  2. turbotom1052

    turbotom1052 Senior Member

    Joined:
    Oct 2008
    Messages:
    1,044
    Location:
    Vermont
    you don't mention the manufacturer of the coater. Have you tested the pneumatic switches? Have you tried using that last unit to print instead of coat? Will it print in register? Will it print with the same impression settings as the other units?
     
Loading...