Adjustment of front delivery joggers on sm102

Discussion in 'Heidelberg Printing Presses' started by Jack liston, Dec 5, 2019.

  1. Jack liston

    Jack liston Member

    Joined:
    Sep 2019
    Messages:
    35
    Location:
    Connecticut
    Hello everyone need some help with the the front delivery joggers seems like there is not enough tension or swing in the gate I installed an new air cylinder and is open and closing fine any help will be appreciated thanks
     
  2. Steve F

    Steve F Member

    Joined:
    Jun 2013
    Messages:
    16
    Location:
    Scotland
    Worn cam.
    Been a while since running an SM so can't point you to its location, but it'll be drive side and probably quite far from where you'd think it would be, at the far end of the connecting/movement arm.
    (that's where it is on XLs anyways)
     
  3. turbotom1052

    turbotom1052 Senior Member

    Joined:
    Oct 2008
    Messages:
    830
    Location:
    Vermont
    As I remember it its just an arm with a bearing that acts as a follower. See if you can find a bearing with a little bit larger outside diameter.
     
Loading...