3 Knife Euro Trimmer

3 Knife Euro Trimmer showing this message on the screen.

Status Machine - Fault
Release Emergency Stop
Check covers and sw, prot, devices
Press reset and air supply buttons

I am stuck here and cannot go further.

Please help

 

Hi sir:

Go with the schematic electrical diagrams , and look in the diagnostic system for Emergency Stop, +covers open( included limit switch, sensors) Reset, and see carefully, if they are out of position, or broken wires, or dirty, or faulty devices.

2) Reset the air supply button, look in the schematic electrical or operator manual where are located( normally in the schematic electrical diagram, they show where is all devices, motor, electrical, Pneumatic, hydraulic,). and again, please See carefully.

Remember your best Invaluable tools: 5 Senses !!!!