2007 102 speedmaster.

Main motor display missing incoming voltage, sbm1@2 temperature over the limit and fluctuate armature voltage and current displayed . Dynamic test codes down below. Svt board replacement did not help.

 

Can you see SRK module in the list of software version?

 

Unfortunately I am not there to look. Press has msk board.

 

It can't as it shows SVT abd SLT error message.

 

Hi sir
interface between sbm 1 and 2 and the svt is faulty due to overcurrent. the sbm is powered off due to too high a temperature on the sbm 1 and 2 location.
Good luck and let me know

 

there were probably errors in the dynamic test that appear but you did not pay attention during the fluctuation.
check if the cooling of the cabinet is good??

 

Hi Adil. Conditions that I described come up on the power up after booting up.

 

Try to check interface between svt and sbm it was an overcurrent that make interface defective

 

There is srk in software version. It turns out to be defective srk. Thank you

 

Good job