2001 heidelberg sm-102 6+lx. Error during installation

Discussion in 'Heidelberg Printing Presses' started by mashriqpress3, Jul 23, 2013.

  1. mashriqpress3

    mashriqpress3 New Member

    Joined:
    Jul 2013
    Messages:
    1
    Location:
    KARACHI,PAKISTAN
    Dear Technician,

    Recently installed HEIDELBERG SM-102 6+LX. 2001 model.
    When we trun ON the Power, after Initializing IPC showing this error
    CONNECTION TO THE REMOTE INK ZONE ADJUSTMENT COULD NOT BE ESTABLISHED
    Regarding this error we checked the COMMUNICATION CABLE between IPC to LIOB ( Light pen in put/ out put board ).
    we Checked the LIOB to another machine and found o.k.
    Also inter changed the IODB ( Ink Zone operating and Display Board ) but no effect on the error.
    WOULD YOU PLEASE GUIDE US TO RECTIFY THIS PROBLEM.
     
  2. rudysbp

    rudysbp Member

    Joined:
    Mar 2019
    Messages:
    10
    Location:
    indonedia
    I have the same eror for speed master 74 year 2002
     
  3. CHOCK

    CHOCK Senior Member

    Joined:
    Dec 2016
    Messages:
    2,852
    Location:
    Managua,Nicaragua
    Which console do you have??

    However do this:

    1) Perform a visual inspection : look for loose and broken wires, improperly seated connectors, loose or broken wires
    misset switch, missing jumpers. and so on.

    Chech for obviously damaged component(components burned or discolore due to overheating);
    Dust + dirt + tear +wear

    2) Reseating Boards and components:
    Edge connectors are a common souorce of problems. Power down the system and remove the PC boards. Examine the edge connector
    for contamination and clean with contacts cleaner contacts. Reseat any loose components such as scoketed ICs) . Reseat the
    boards and power up.

    3) Power supply checks:
    Check the power supply for missing voltages and voltages out of spec. A digital multimieter DMM can be necessary, as
    voltage specifications are quite tight: logic supplies for example: must be within + 5% percent of 5Vdc. All the
    multiple supplies and all must be checked.

    4) Board swapping:
    Board swapping involves the substitutiono of a known godd board for a suspect one.


    5) Clock for CPU:
    Check the frecuency with frequency counter or a DMM included frecuency counter( like Fluke DMM)


    6)Reset CPU:
    reset cpu see the attached schematic.

    7) Components ; Rusting+Dry+Colder joint solders

    8)Cables; Corroded+Broken
     

    Attached Files:

Loading...