imaging

Hi Everyone, We have recently installed a QMDI PLUS. After 6 imaging cycles we experienced a problem on Unit 4 where DIODE 5 stopped imaging. After removing and replacing the same DIODE, the zone then imaged about 80% width. I then replaced the problem DIODE with a replacement DIODE but the...

Good Day All, When purchasing Laser Diodes, what should be the full power value of a diode? How can we test the strength of a diode? Please advise. Regards

Can anyone tell me if my diodes have gone out or what the problem might be. The imaging on my yellow plate is aborting 1/2 way into the image or is only imaging 1/2 of the plate. My press is a 2002 QMDI Pro 46-4. Need help soon. Thanks Eric

Heidelberg Digimaster 9110 network imaging system 2002 from United Kingdom Date of manufacture 2002 45 million impressions Full service History available Sun Ultra workstation with full license 1 x paper supply module 1 x marking engine with paper supply 1 x inserter module 1 x stacker...

This must be a dome question? I would realy like to know what to use to make positives to burn onto the plate. Lets start at the beginning. 1. I have Heidelberg QM46-2 press. 2. I still use light and chemicals to develop my plates. But i am having really big problems with the printing of...

and using a digital press? We're looking to move from just a Docucolor 250; to somethign a little more advanced. Does Digital imaging provide the litho type print, or does it still look digital? What are some of the short falls when comparing to true offset and digital press? And lastly...

I have a message TFLT on my imaging screen. MANUAL states: "Temperature status of the heat sink on the power driver board." Any ideas? Thank you!

:)HI I have a Ryobi DI 2003. Certains sections on the plate on the 1st unit are not imaging completly. Increasing the imaging strength on the lazer unit has not rectified the problem. The machine indicates that the lazer is ok. Any thoughts or suggestions.