3302

Lots of great equipment Please Contact Leonard Enterprises 18 Laura Street East Providence, RI 02914 401-438-8802 shop 401.338.0420 cell 401-438-0099 fax Pat@EmailLPT.com www.EmailLPT.com

Hello, I am hoping to get some input from people who know. I am looking to get an old GTO. I don't know a lot about them but everyone I talk to says that would be the best press for me. I print on a volunteer basis for a group I am part of. I print mostly small half letter sized saddle...

Hello everyone I'd appreciate your comment for helping me with below questions What is the different between 552 3302m 3302h 3302ha And what is alcohol? Also why hidelberg gto is better than ryobi Thanks for your help

I am looking at buying a two color press to replace are ab dick 8970. The two i have in mind is a used Heidelberg qm 46 or a Ryobi 3302. I am not looking to print process work mostly black 1 color with some 2 color. Witch press do you guys think is a better press and has a better feeder for...

When running stock that is either black or has a flood of black on the back, the impression sensor registers it as a jam. I have tried turning it off, but then I get no impression. I have tried cleaning it, putting tape over it, blacking it out, taping white paper over it, scotch tape to dim...

Hello. I'm running a 3302 with crestline dampener system. I mixed new fountain the other day and the press ran great for about an hour. Today when I fired it up the fountain was very foamy in the tray in the first unit. Any ideas?

We have a 3302 here in the shop we don't use much. It is nice for those 2 or 3 color envelopes though. The battery light came on so we got the same battery from a store down the street changed the wires over and tested it. The voltage tested correct. After we put it in we turned the press on and...

Have put on all new grippers. Trying to rid problem of doubling on second print unit. No luck, did find that rasie/lower device on second unit was locked up, greased and oiled up to free movement. This did not help. Is it possible that their is play in raise/ lower linkage?:confused: This...

Can someone PLEASE explain how to adjust the buckle on the 3302? I have it all out of wack and I'm printing 4 color on 4 jobs 6000 impressions each. Thanks

we have a 3302 H, it has leaked water around the damping system since day one and nobody has ever been able to tell me where the water is coming from. the side squeegees are replaced all the time and still drips and washes out the image for 25 or so copies,then prints good then drips again...

we have a 3302 H, it has leaked water around the damping system since day one and nobody has ever been able to tell me where the water is coming from. the side squeegees are replaced all the time and still drips and washes out the image for 25 or so copies,then prints good then drips again...

For a combination of some acceptable-quality process color work in two passes and some 2-color and black and white jobs, which is a better press: an A.B. Dick Century 3500-S with stream feeder or a Ryobi 3302? Will only be only running ~1/2 million impressions a year. Do these presses have...

Can one run one-color jobs on a Ryobi 3302 as easily as on a one color press?

Obviously neither is a perfect choice, but for printing runs of 1200 11x17 full process color (CMYK) pieces with medium to high ink coverage on gloss stock, which press that is within my budget would be a better choice: a Heidelberg QM 46-2 with the shared blanket cylinder, but heidelberg...