Is it going on impression when it hangs like ti suppose to we had that a peen once? It quit and the plate was just a little loose
We use crisco to lube the front of the lys it works good. The hard part is getting all four shifts to clean up properly and not get in a hurry....
Tail clamp on eight is not opening all the way have to bend tail to fit on auto. Seven won't push down on pin with out help. Six is broke do it by...
It's an ls 40p no fault shows. Need to check the speed and look at neumatic but we been dragging the first four all week so haven't used it.
is on pins, is full apc tail goes in just when wheels come forward to push it in it just comes up short about a sixteenth? I will see if its...
When we hang plates on our lithrone forty inch eight color the fourth unit tail don't go all the way in the clamp?
Did all that fix it. I just started on the back of a 8 color komori from around 2005. Same cracked foot hose problem havent fixed hose yet no time...
Have you thought of more then one say a cheaper two color with perfector for type and old heildberg mom or even half sive speed master for covers...
Bounce dryer sheets and scotch wiskey is how i deal.
Your rollers are too off re set your rollers to zero the make sure you have them 1,1,1 and 3,3, in the roller sets. :>