Hi all, Does anyone know of any PT-R8100 techs. I have a registration problem from plate to plate. Any advise would be appreciated, or can call...
Sorry.. PTR-8100, punch, using thermal plates 40x30. machine was manufactured in 2004
Hi all.. is anyone familiar with the CTP not burning square on the plate? One side is out by as much as 1/8 or more sometimes. Any suggestions...
Is your problem resolved? It's most likely your clamp. It could get weak on one side forcing it to go the other direction.
Does anyone know what the problem is, if my press prints 1 sheet good then the next sheet loses pressure on the 2nd unit right side of the...
That's me.. I pulled out the blanket cylinder shaft and replaced it so im sure i was a few mm. out. It seems good now. I got my 5/16 grip and...
Pls. if possible help me with the feeder timing and all the cam setting. What does the cam on the blanket cylinder control?
I took out the upper infeed roller and made sure the bearings on the ends were ok, it's good. Lower feed roller is fairly new and no signs of...
From #10 envelopes to 8.5x11 20#bond papaer the whole timing is out. Some sheets feed properly and some barely make into the grippers, some feed...
Its the pin on the bracket that holds the blanket.
The pin on the blanket cylinder keeps snapping. it's the pin that locks the cylinder to the shaft which controls the cam on the operator side. I...