It is too dainty... Warning to people looking to replace their iGens with an Iridesse. DO NOT DO IT. It cannot handle the volume like iGen.
You need to verify that the static eliminator power supply is working on the PR Module.
Where does it say 400k for 1 bottle of carrier?
It can if you have the newest upper tray.
15 minutes and not really
That panel you have open needs to be closed by the way. No guarantee it will turn on after, but that panel needs to be shut for that fan to...
It may not be phased properly.
IGen only guarantees stacking up to 300gsm. You'll most likely have to run that to the top tray
Do you have a pantone book that compares the pantone to CMYK? There's a whole boat load that you can't dial in no matter what you do. A lot...
Did you edit the pantone in the custom spot color editor to change the CMYK values ?
Correct, if switching from Orange to Blue/Green. However, if you already have orange loaded in the machine and setup. It only takes a few...
This is only true if you're changing to a different 5th color. If you have orange in the machine and you want to switch to 4 color only, it...
iGen5 is available with either low gloss toner or standard toner (glossy toner). However, the extended gamut kit (orange, green and blue toners)...
haha, good luck!
Just check the oil level in the RAM occasionally, if that runs dry you will have a mess.
What's wrong with the old lamps???
PFA is teflon. 604k54720 is the rough external roll.
You can still used a razor blade but you have to be careful. I still do on my presses if its really bad. Xerox always recommended using...
What are you using to scrape them? There were two kinds of external heat rolls, smooth and rough. Smooth isn't used anymore.
I don't believe so.