STAB or CPUC
Are the first few sheets Ok and then starts to drop off and is the strip of red running along the long edge of the sheet ie left to right on the...
8xxx codes are HFSI counters
One (iGen4) has normal toner. The newer machine (Diamond) probably uses matt (low gloss) toner. One way to find out is to look at the licenses...
You have an air lock in the upper L bend. Probably has been installed with a slight up gradient. You can run with the valve removed. In the...
STAB. Needs a new one
You need to bring your humidity up to approx 50% for best results
There is a static eliminator just before the entrance to the VGT belts. It a square aluminum bar. Give the underside a wipe to clean it. If...
As far as I can remember the pre clean isn't monitored for OC
Could be the cooling fan on the HVPS failed
Check the Ozone system, full pre ozone filters, failed blowers etc
The switch changes power control mode to local or remote. Can't remember which position is which
Probably the STAB was affecting the calibration strips that the CPUC reads on Cycle up and it calibrated for it :)
Those are streaks not banding :) Multiple suspects. Fuser roll worn, STAB worn, PRB contaminated, dirty CPUC, Recharge Corotron, Charge...
Hi Nick It has been a while since I touched an iGen and I left before the iGen5 was launched. I seem to recall that this was an issue elsewhere...
The older stuff is better for laminating a there is less silicon in it. Down side is that the fuser roll life is decreased. Upping the fluid...
Looks similar to developer starvation. Try new tanks and developer - they don't last forever
There are two cam motors. Both are on the rear plate. The upper left one cams in the fuser roll, external rolls and donor/meter roll assembly....
It doesn't require a puller - it's just awkward to get off. They should have lubed it at every change so it doesn't get stuck on the shaft. I...
Is the blade height correct and set? It is adjustable by moving the sensor next to the actuator flag. You will need the procedure and PSP...