I forgot to come back to thank you for the reply. We don't usually do this fold so i'll try next time. Moe
Hello, We have a 4 up Stahl folder and usually do small brochures. We tried yesterday a trifold(i hope that's the name of the fold) on a 3 up...
Hi, We have a GTOZ 52 and one day just like that the water pan rollers stopped working. Turned out that it was a burnt fuze in the electric...
Hello everyone, We have a used 2007 PM74P. I've using it with no problem until yestarday that we tried the perfector for the first time. I...
Hi everyone, We have a small laminator that we use very little. We've been having a bubble problem lately.(look at the pic) we're...
Peterh, What i call sheet separator roll(only because that's what OM calls it) is shown in pic 3. In pic 2 you can see the "barrels" that guide...
Hi everyone and thanks for the ideas. Finally found it. The sheet separator roll was set too tight. While it did not affected register, it was...
Ill check it today. How do i "silcone" the bar? Grease it? The powder is the same that came with the press. Since it looked the same we got here,...
Hi, Device is a WEKO AP110. I checked the superblue net and it was dirty but no ink buildup in problem area. Very dusty. I vaccum cleaned it. I...
Hi everyone, We recently installed a used 2007 PM 74-2-p and everything have been working but i've been having trouble with the anti-setoff...
SORMZ: 2 Colores, Recirculador Royse, Secador Infrarojo, excelente registro. Precio MX $ 525,000.00 AB DICK 9910 XCD: 2 colores, T 51 AE,...
It did! Thanks Georgie. Now... I had to go back to my old fuser for when i put the new one, machine again give me the 010-320 error code on the...
Hi, I tried to replace fuser while machine was on and got a red screen saying there was a problem so i went back to the old fuser. After a...
Hi Socrates, sorry for not answering before I've been experimenting with the machine. I've come to believe that my problem is not chemical. I'm...
Thank you mqgpress and socrates, I looked at the rollers "pins" and they looked allrigth.(In our GTO the roller that recieves the z roller...
Alcolor problem Hi, I've been here before for problems with alcolor(on GTOZ). I read the posts in this tread and i'm experiencing one of the...
Thanks Mechanic, I checked the pressure and it's ok. I'll keep this sheets close to the machine for future reference. Just one thing... From what...
Hello, Just got a used AB Dick that came with operating manual but i can't find in it (manual) directions on calibrating form...
Thanks exheidmech, The guy who came said the diagram showed so. I just could not belive him. Now i do. Interestingly enough, if i hold the slow...
Hello, When i start the GTOZ with the run button (either feeder or delivery panel) it automatically goes to pre-set speed(like 6000 sph if that...