By margin head you mean front lays?
The flywheel and the feeder head usually move during shipping. I will remove the drive motor so there will be no brakes
Hello fellow printers I'm about to move to a new place. I have to detach a feeder of 1980 SORM. What markings should I make to the magnetic...
Hello guys I need help operating a k66 stahl folder eg. Fixing double feeding & speed controls
Problem solved after replacing the blancket and adjusting the cylinder pressure
Thanks guys
The plate gets torn out of the machine after about 2K prints. abdick 8810 Any idea about the causes??
Dear fellow printers I have a buckle problem with an Abdick 8810. ( 0 buckle @ no 15 on the buckle dial), which caused feeding problems. Trying to...
I followed these directions. The form roller reaches the plate cylinder but with little pressure. Problem not solved,I will acquire a new roller....
I can't find the sleeve bearing or the screws that you mentioned. Anyhow there is an allen screw adjustment at the sleeve on the non operator side.
Yes Mr. CHOCK thats the one.
It's Am 2675S model. I've a problem with the spring that is installed on the cam at the side of the cylinder. Can't manage to find one that works
Dear Fellow Printers I've installed an old Am Multigraphics. Can't get the spring loaded plate cylinder clamp to work, after replacing some parts...
I noticed that Only when the form roller is pushed by hand that reaches the plate cylinder. Why would there be such a gap?
Thanks for your reply There are eccentric adjustments on each side. There are springs on the collars. They're in good condition. What about the...
Dear fellow printers I'm trying modify an Abdick 8810 so that I can install the lower form roller (1) try to increase the range of eccentric screw...
It's 8810
Dear fellow printers I've a problem with adjusting the lower form roller. I installed an original roller with the standard diameter shown on the...
Dear Fellow printers Problem solved, Press is running.. The b45 switch was loose and not in contact with the cam. Thus the tapes were not stopping...
I mean a wiring distribution diagram/schematic detailing all the connections between contactors