Hi, can you tell me what year the press is because the bridge roller adjustment and setting does change depending on the year. Cheers. Hawker
Hi. You're probably right. The delivery of the printing press may have had excess spray powder built up and was dropping spray bombs on to the...
Hi, when I load a memory card for a duct setting sometimes it reads number 80 on the small screen on the console and I have no duct setting. I...
Aqazi81, if you can't get a setting on One side of the press, there is a good chance that your adjusting nut on that side is broken. These nuts...
Hi, to maintain a desensitized damper you should increase your fountain solution. If you have a conductivity meter, you should check your...
Ink money, thanks for reply, this makes total sense. I know the residue that you're talking about and I'll give the grip and tail edge of the...
Hello panos, I have been printing for over twenty years and have worked for about five different companies, with the company I am presently...
I have asked there technicians that they employ here in Australia and they looked a bit confused. They require more training from kba in relation...
Hi, My company I work for has recently purchased a kba rapida 106. On occasions we experience excessive hickies even when the ink and rollers...
Believe me, listen to rossio. I have ran a tok in the past and they are a headache.
Oh! Thanks
Hi Shane , hard to say without looking at it. Where a bouts in aus are you?
Hi, and welcome to the forum. I used to run a tko about 20years ago. We never attempted to run multiple colour work because we had a couple of...
Hi William, while setting your forme inkers and damper to plate, at this stage, while the rollers are all in contact with the plate you should...
Hi meny, could you explain what CIp files are, I'm not familiar with cip files. Even when my density is correct it still piles..although it will...
Hello, I run a kba106. With uv. We have been experiencing excessive piling lately. To help combat this problem I have reduced the ink on the unit...
Anuj, how far back from the grip edge are the lines? For now adjust your circumferential oscillation slightly on one unit and see if the line...
Hi, firstly I would solve problem by process of elimination. To begin I would take a solid print without using the dampers, if the lines have...