A picture of the panel actually help, not really sure if there is a DIPM or just EAK's, could be blown fuses at the power distribution board...
Azr can works in mode 3, the 24v for the valve comes through that 15 pin connector, its just a jumper from within the connector from the 24v line.
How do you know you are not getting the voltage on the valve, where are you testing this on the bench by yourself? Is it an alcosmart azr can? I...
The compacts are notorious for locking up due to low 5VDC on the ZSK, usually wiggling the power connectors on the ZSK and the NTM brings the...
Hi, that is a very old software, get in touch with heidelberg, they will offer you an upgrade to 32.A, an MC7 IPC, probably a new screen, an...
You might need to go into service and pull out the errors from the auxiliary drives
Bad BEK, REK2 or the communication cable it seems. Also make sure the power supplies are lit up green.
Hi, do you hear a click when the valve opens? If you do valve is good, if you dont its probably stuck, sometimes it possible the person who worked...
Hi Chock, I have managed to repair the supply the red light in my particular case was safety shutdown since the 5VDC output rail was at 9VDC...
Hi Chock, I have checked there are no shorts, which fuse are you referring to? I have checked all the fuses, the main 16A fuse and also the on...
Hi, I have an NT33 for a suprasetter, when I try to test the power supply by supplying 220VAC and shorting the remote pins, the fans spin for a...
Hi, I have a display panel for a stahl folder KD66/4 as shown in the picture, the chip marked in the picture is a GAL20v, the chip is shorted and...
what is the condition of the machine now? can you share some pictures? this is the first time you mentioned EAM board burned. are only feeder and...
Since you are in Europe the cheapest way is to get in touch with Heidelberg and buy it from there.
the reason you can't access other codes is that the I/O board for the screen itself is dead, which is EAK13
Hi, count from the right, swap the 3rd eak and share a picture of the screen, your errors clearly show the problem is with the EAK13, doesn't...
Well this has already been discussed, the light either Green or Red should be ON so there is definitely a problem there, on the delivery at the...
Buckling or bulging of the board as it hits the infeed results in wrong ultrasonic sensor output, make sure you are running the correct air...
The init and dyn codes of the SSKs are important here. If the light on ssk turns on once at start if means the board is active and is out of the...
In newer machines we have a board for external input to the main cabinet called the SEM, for your particular machine if I remember correctly there...