reclean filter make sure oil is half way on glass press will not run if filter is dirty
5 ply seem to be the most versitile iwould go that route we run them all the time no problems prisco has a decent blanket good luck
thank you control this press also has a perfector and scanning densitomer alot of crap can go wrong. ran rolands for years seemed like the ink...
WE ARE LOOKING AT A roland 3o6 semi auto plate with rci and dahlgren 120mm imp need some input thanks
re atach the grey wire im not 100% sure but some bad **** might happen like overthrow wont work
you should get at least $30 an hour any thing less tell them to bite your ***.
the pins are there for a reason ican understand the pressmans frustration if he can hang the plates onthe bullseyes that are on the cylinder he...
get a ryobi 3302 and a c9000 envelope feeder will run forever. and you wont have digital techs living in your shop you could get both used for...
go with bottcher less headaches more production
cuold be damp try alittle electronic cleaner or compressed air
auch there is a certain position for tray it has to be slightly tilted tword the drain plug but not so much that the water pan roller scrapes...
your ink may be breaking down is your water at thr right tempature
first youneed to put some ink on the ends and middle of the metering roller so you can stripe it to the pan 4mm then to fat steel 4-5 mm then...
you need to take off both dials remove all the allen screws that hold the cover on/ the the cover should slide off the shafts where the dials were...
i think you're right they should try a lower tac ink might help
also try to keep the suction pads clean on reversing drum
do you mean the bearers ? can you post a photo of problem?
try to run your heavier covrage last when perfecting and make sure the perfecting unit get a little more tlc keep it clean and lubed and it will...
call atech ihave seen others try to remedy this and they screwed it up beyond repair or waranty
there may be some truth to music tames the savage beast!