Hello I am having an issue with my 3302 while printing tower 2 will not duct ink in auto if I select manual it ducts though. Any help would be...
Good call Yorkshire !! problem solved !! Thanx very much
I will check that thanks
Water is hard from the source but goes through a DI filter and enters into technotrans at 500 my font is at 2700 conductivity and as far as...
Hello having some plate issues on my lithrone 6/28 noticed lots of spots on sheet in non image area in black also a band of more concentrated...
sorry yes they are near the impression cylinder some times oil will get inside. I just pulled the plunger out and cleaned with alcohol good as gold
On the op side frame there are two, one for each unit
The impression light flickers occasionally when I run uncoated or dull stock but does not light up at all on this dark stock and yes it runs with...
Tried that, still no dice
hello I am trying to print a job on duplex stock, white one side dark blue on the other. The press starts up, takes a few sheets into the press...
Did that turns out it was a sticky solenoid thnx though
hello hope someone has had this problem and can help, basically the press stays on impression when the paper feed is stopped. it is the second...
It did rub off a bit but we sent it out and had it UV coated
Thanks for your help guys got the job done no problems used a little heat fully oxidizing inks would have dried sooner I will try that next time.
hello i will be printing a job today on vinyl. I will be using hard dry inks and large micron powder my question is should I run heat or not ....
Thanks for you responses turns out it was a blanket issue. Was using a blanket made under the name aquamarine . I pulled a old day blanket I had...
hello I have a strange pattern showing up in a print job. The job is on a gloss sheet and is showing a moray like pattern in the black. It shows...