Press goes on impression automatically, but does not go off impression when feeder stops. Any ideas. 1993 Series 259 Offset Serial 23990-B7518
Every morning when press is turned on circuit breaker trips --- oil red light on --- reset circuit breaker and everything is OK for day. Next day...
Pressman had a jam up and we get little rips in paper on gripper edge. Figured it was one gripper bar and set each gripper to 65lb. cover...
Anyone have any ideas. Is there a fuse or circuit breaker?
Never changed this before. Is there anything special I should know
Found out that pressman was using wrong oil (hygrade motorcycle oil) --- drained oil, cleaned filter and started refill with the correct oil. I am...
I never saw this before. Does anyone know the problem.
When I press the peddle to punch nothing happens. The drills do not go down. When I turn on machine, I hear the noise like when you push the pedal...
The switch has 3 wires. Before I put the switch I tested (pushed microswitch down - circuit on). Mount switch, switch works opposite. Don' know...
My delivery pile sensor light is on normally, but pile does not go down automatically. Need to push down button every once in a while. Before...
I put a new ink roller in under the dampener rollers. Removed the water tray, put it back in, leveled from left to right. Water runs all over....
What is the procedure for setting dampener rollers on the 202? Keep getting scum on left hand side of sheets, 3/4 of the sheet is completely clean.
Any instructions? Removal of forward and sideward controls on side panel to remove side panel on non operator side.?
My spray unit is clogged. It has not been used for a year. I scrapped the tube and found the powder is very hard and mixed with oil. Any...
New pressman has not used it before. Switched the on switch next to the unit nothing happens. Previous pressman had no problem.
Running a 2 color job. The dampening rollers on the top unit stopped turning then started turning. Seems to happen at random. Probably 90% of the...
I would like to get a plate punch. Does anyone not what I should ask for or the spec. Of course, I would like to buy one used. Plate punch is 8.5"...
Every 4 - 6 weeks the taper pin in sheared. Any suggestions about what to do.
Ink Adjustment - Ink fountain roller does not touch the next roller 207. There does not to be an adjustment??
Are there any service providers in the Philadelphia, PA area? Better than Manroland.