Longshot here, i know this is not the most traveled forum these days...but worth a shot. I have an elderly IGEN 4, and I get this error...
no accompanying errors either. I'm totally lost lol did my usual, vacuum the cleaner brushes, clean etacs and mobs. mob and calibration an 951...
Came in this morning to a perplexing issue.... IGEN 4 is fine, no errors.... nothing. Starts up, gets going. BUt just as the sheet hits area 2,...
last few weeks my color has been garbage. I let it go just babysat it. Called in the rescue squad this week. they fixed that-cleaning prob. now......
EU Evaporator filter full. not sure what this error is saying....
All, cant remember if i ever made a thread on this... but its happened before... I just upped the fuser speed.... whats happening is, it LOOKS...
got a phone call with that exact question. I know nothing about the specs. Am i a Test pilot again? anyone else do something that could be called...
Like clockwork, we're now in the midwest fall, and almost instantly, its gone cold and dry. The last 5 months, The igen has been stacking...
***SOLVED see second post. Pinscorotron grid to PR slope out of range. accompanied "log only" faults: 09-4414 VMC at minimum 09-4464 developer...
also has"too many registration marks" at the MOB sensors 6-3015 6-3016 reboot, and cycle the DFE it ran for awhile... now im dead. :/
Ive had this before... but never on normal paper.. usually only REALLY light gloss. Paper coming through the transfer 'bubbles' or 'bows up' in...
entrance decurler home position fault. comes and goes.... coming more than going.... here's what iv'e been doing.... 1-clean sensor 2-reseat...
software reload, followed by a connector loose on reg board.... few days down off and on. came back after the latter, absolutely will not run my...
my Igen4 started giving me 9-1100's out of nowhere... so. restart, clean everything... cleaner,etacs etc... wont pass 951. So restart again comes...
Been dealing with this off and on for a while... thought id look deeper into it. jams with "late to vgt 2 exit" 11-5510. its 14x18 55# offset...
OK. ongoing, but not a dealbreaker problem. Im THINKING developer? Igen runs good for awhile... but after sitting, no cycle up, 9-1100 run 951,...
Not much activity here these days..but ill throw this out there... We have original PDF's made for our big digital roll press. I do rework,...
Long weekend of kids' soccer, im exhausted... Had a rough monday morning of communication and power supply faults... got through it, breaker off...
inboard ETACS LED Out of range. Ive cleaned them, will occasionally pass 951, then run for awhile but many times its this error. if I let it sit...
about ten of them. all say missing 36v. plus inline spectrophotometer fault. cant get past it...ideas?