Measurement is taken with a depth gauge of your preference, from the end surface of the intensifier block to the piston. To do this, remove the...
Hey Cali, What model year?
dsl, it the latter, try removing the 6mm fasteners (5 mm allen caps), clean and grease the pin and the bore it runs in, put the pin back in but...
Most common would be the red nip bars, wiggle them to see if you can clear the error.
LLS - Plenty of us old timers around the states, not working for Heidelberg anymore either by choice or by chance.
I WANT IN ON THIS ONE!! Can't believe how lucky the guy would be who gets involved in this...oops, did I say "lucky?"
Hey oursork - no matter what the direct cause of the problem is, rule of thumb dictates replacement of damps minimum one year and inking forms...
I've had limited experience with Dahlgren systems, troubleshooting wise, but replacement of the pan roller is not a service call. If your model...
Hi ft Walton - as discussed, loss of urethane on tips likely would have alerted you gradually but that loss coupled with a little wear in a...
Not unusual to be able to pull sheets out of double transfers as the spring pressure is far less than at impression and first trx
Try running sheets into press(impression not necessary), stop press with sheets in, and pull on tail of sheet as it is in transfer at suspected...
Ft Walton - if the problem just started all of a sudden, it's not likely individual gripper settings. If you've seen it coming on gradually over...
Now sounds like combination of loosing sheet due to lack of gripper pressure and tack influence. Does it seem worse at start up, after press has...
Have you determined it is not being caused by side guide? Try running sheets w/o guide. Recent jam up at feed board? Kind of thinking sheet...
Are the first two units running, fitting and registering together but slur going into the third unit? Printing perfect or straight? More info...
We should all take a lesson from you, Meny! (regarding your healthy diet, not your preference in printing machinery :))
Thanks, Aqazi, my humor is appreciated after all. :) Steve
Hey there Meny - My sincerest apologies if you believe I've been disrespectful. Maybe a difference in means of communication or semantics ruined...
No surprise Hey Paven- Meny's surprise will likely come as no surprise. He's going to try to convince you that Japanese is better than German!!!...
When checking LLS's recommendation, don't neglect looking at the brake relay tied into the backward direction relay