I have ran a 3304 HA with a low serial # for many years. Can answer any questions you have. Email me rchesser@sbsduluth.com
I'm very interested in this press. Please send contact info to rchesser@sbsduluth.com
Where in Canada are you? Could I get some contact info?
This is a dirty sensor Clean all sensor the problem will go away. Good luck
There is many thing that can cause that. The curl of the envelopes. Ripped sucker feet. dirty sensor, back stop too tight. I have run Millions of...
I have run a similar press for years. They are very touchy if you don't have the water roller set right you will tone or drip. Chrome to metering...
I carry a fine grain powder in many different sizes. We service area in Mn, Wi, Nd, and Northern Mi. You can email me at rchesser@sbsduluth.com...
I have used poly plates for many years you can't go wrong if you run lengths are under 20,000 as for the quality that's all up to the operator.If...
I run a 3304ha and we print many differant size paper and thickness. When i run large quantites of thick paper my blankets get cuts in them. Is...
I also Run a 3304 I have seen registration problems with the grippers you can isolate the problem by checking several sheets in a row if every...
Hey all, I run a small 4 color ryobi and have been having issues with cover stock. The Last Month or so The paper I get from the distributer...
Is it in the same spot as the sucker feet pick up the paper. If you use after market sucker feet they leave a residue on the paper and tranfers to...
robert@christieprint.com
Starprint, We love our press. It will run 11x17 gloss we use 80lb gloss more then 70lb there are some problems with the lighter gloss stocks they...
I do believe they went out off business. Try to contact Press tek they might have parts. Good Luck
There not telling you all the costs involved with the Ryobi 3404 di The ink is way more if you do PMS work ouch. Tempature controll is important i...
We were going to buy one of these a single color presses to replace our ab dick 9870 and it would not print very good it seemed like there was no...
I have the same problem I run a 3304ha I have not found the cure yet . If you over tighten the outside blanket bolts it causes this problem. If...
We have a 3304ha running poly plates and looked at getting a DI and put the number side by side and they don't match up.The supplies for the DI...
Check the pressure of the imput feed rollers the first rollers the paper hits if the pressure is off this will trip the sensor but everything...