Hi all Can anybody give me some feedback about the roland 700 hiprint. How it runs, positives and negatives all comments welcome. regards john:cool:
HI dutchb further to my earlier reply, if the rubber metering roller is moving over time, on your next maintanance time slot, take the roller...
HI dutchb sounds like the rubber metering roller is worn on the edges you need to check the measurments of the roller, if worn replace with new...
HI jong586 I also run a roland 700(1995) but not with a coater. but i have operated coaters in the past. have a word with your supplier they...
Hi guys first a question for rapidaguy off topic, do you know if roland make a suction brush for a roland 700, this device would be attached to...
Hi could anybody tell me how they deal with powder problems when laminating, is there any kind of suction removal system prior to the laminated...
Hi can anybody tell me if there is a suction system for a roland 700 wich would fit to the infeed area and remove any unwanted debris/ spray...
Hi griznarf Have you been told that the customer wants it between the units for a specific reason, could you locate the UV lamps in the delivery...
Hi, as well as the above suggestions, equally as important is to re-set your damp pan rollers and reduce the amount of damp on each unit,example-...
john.higgins@sky.com
Hi. If you are having problems with paper clinging to the feedboard, try spraying the feedboard with silicone spray then buffing it dry. if you...
Thanks for your reply, we are familiar with the process that you discribed, i am wondering how do you know how much tension you need?. do you just...
Hi peheidelberg we are about to start changing tortion bars and replace gripper pads, how do you get the correct amount of torsion when setting...
If a manager needs advice on telling there staff not to do something that could be bad for the machine, maybe a new manager is required
Hi johnboy I have operated an old KBA rapida and i have been to see a new one demonstrated in germany and they both mark the back of the sheet,...
Hi all can anybody give me some tried and tested ideas to alleviate the problems of static in a stack of paper whilst feeding into press. I am...
Hi bryan It does not matter what you call it,the answer is what you need to get to, exheidmech is on the button with his comments. I am at the...
Hi cayugap There are sensors on the perfecting unit wich tell the press what position it is in , do you think a sensor or limit switch might be...
Thanks for the reply,please refer to original post, the wedge/template is used to set the tips to the pads on the transferter, i need to know if...
Thanks for your reply steveo, If your demo guy knows about the perfector or the standard transferter that would be great, but we realy need to...