need an experienced electrician for my single colour vs34m we are based in north west england pr76en
Problem making plates on unit 3 of qmdi plus Got message never had before 'time out waiting for void signal 3' Anyone any ideas please
my qmdi after making plates was slow at changing from 500 revs to normal speed and keeps going back again.the feeder pile can be raised with the...
hi paul have hard wired the two red wires at back of x7. whenever weve had problems before with x7 it has caused the extraction pumps to switch...
it was svk3 board faulty replaced and then ok cheers eric hyde
Hi When switch machine on the extraction fans not coming on no lights come on at the console cant inch or run the machine Computer comes on...
Thanks Paul and Mr Heidelberg Its not TTK or delivery grippers have tracked down to encoder. Changed the encoder made no difference put original...
hi qmdi plus new installation checked all wires runs for 9 seconds at 3500 per hour then stops showing 15-01 fault for only a fraction of a...
Can't image or spool plates Had initial problem of blue screen with flashing cursor in bottom. Corner. Replaced SVK board and got into press...
Does anyone have a pdf of uchida 800 collator Instruction manual Would be grateful if you could email me Cheers Eric Hyde
Does any one know where I can source Hard drying inks for use on Hberg DI also need Fluorescent Yellow Preferably Hard Drying This is so can print...
Hi I have soldered the ac red leads direct to back of board so no problem with contact had a problem with transformer connections not being tight...
QMDI CLASSIC PROBLEM Have a problem with machine on run when printing or not printing. The machine stops dead the extraction fans come on for a...
Need to find spares manual or pdf for hamada 234k 2 colour and where can get spares from
Thanks Marc and Jan Cant find any Lancashire Whiskey distillers so will have to be Scottish
Thanks Jan and Marc Can Anyone Help with Classic model Software? Thanks Eric
Thanks Marc and Jan Dont have back up on RIP so need software any ideas other than new drive and software from heidelberg
I have boot disc, will this enable me to install to new hard disc even if i then have to calibrate the lasers and registration? if not can i get...
SCSI Hard Disc has gone down on qmdi trying to get fixed so can copy to new hard disc but have the following floppy discs :- boot disc, update...
