The speed on the folder will not change, we can set the speed to whatever but when the enter is pushed it just stays at the 4500 per hr. Same...
2003 SM74P slowdown motor completely stopped turning, it's not froze up. There's no movement at all, is there a relay or fuse somewhere that...
Is there a calibration option for this monitor and computer combination? See attached photos. Thanks
Receiving an ink barrel (fountain roller) error. Have to reboot press to clear. Happens even when the unit isn’t activated on council. Need to...
I have a 6 pocket 1997 that’s been on the floor of a company that I have started working for that hasn’t been in use for sometime. I have been...
What parts have to come off to get to the ink key motor to replace it on a 2003 SM74? It looks like the clamp that snugs up the ink foil might...
Can someone tell me what the current version of the XMF client for Macintosh is and what OS it supports? thanks
Is there away to time the envelope feeder going into the gripper? On our inserter the envelope is entering the gripper so far that it's tearing...
2003 SM74 6/c perfector What causes the blanket washers to kick the press off when used? It flips a bar over that seems like something is...
What’s operators doing for cleaning the back cylinders? We have an SM74 that has the back cylinder cleaners but they don’t do the best job. We had...
On a 2003 SM74 we have a bearing on the gear side of the press is shot. There looks to be a clip ring that holds it on, once that clip is removed...
We have a DI 950 that when trying to run an A6 with a flat card measuring 4x6 the trial piece works just fine but when we start the job it will...
I’m looking for a m2-198-1283 02 motor. I know these are readily available. There’s a place we were buying parts at I believe it was in Greensboro...
Is there any way to calibrate the sensitivity of the touch screen on a 2003 SM74 with mc2?
We have an old (1987) 4/c MO that keeps blowing the bottle fuse in the water unit. We swapped out this board with another unit and the problem...
We’re getting a low pressure in pneumatic pump code 15. Checked all the lines seem to be fine. Is there another screen that tells where the error...
We have been having an issue with the PC not powering up when we power up the press. Today the only way we got it to come on was to open the hood...
Looking for a 32 channel data cable part number is 100098852V00. If you have one laying around post here with what you need for it. Thanks
2003 SM74 6\c. All the blanket washers stopped dropping to blankets & cylinders. Water & wash are pumping up to the cloths as it should. Any...
We had the timing chain gear break on the feeder on a 2003 SM74 (626-151). We are taking the new shaft and gear to the machine shop to get them...