Has this started all of a sudden or was it from day 1 with 0% alcohol? Zero alcohol tends to require clean source H2O and a darned good fount...
Thanks for the understanding. It was a wrench but completely the right thing to do. In hindsight (which is a lovely thing) I ought to have made...
DJ actually helped me out of a deep, deep financial hole (actually, I'm not sure whether he got me into it in the first place :D ! - however,...
Residual heat...well I admit I didn't check stack temps...no need since we'd never had an issue before (or since...even on the reprint) We've...
Sounds like a reasoned assessment YG However, there was 48hrs between print and Spot UV so I would have thought that would have been ample time...
Update:: Just had the reprint back from the same supplier...same inks, same paper, same coating but this time no 'blobs'
Printed on a Heidy CD 5 colour + anilox end of press coater. Air knives and IR. It was a 3000 sheet on 170gm silk run so around 45mins …both...
Hi guys, it's been a while since I've posted but here's an issue that I hope someone somewhere can shed a little light on. I've attached a...
The legend plate on the last unit operators side will show the undercut of the blanket cylinder and the amount of overpack required. If your...
We're still experiencing poor wash -ups does anyone have a clue as to how to increase the length of time that the spray operates? As previously...
Komori every time...I have owned Sprints and Lithrones from 26 to 28, perfectors and straight, from 2 to 6 col...all have the same ease of use and...
Check for wear in the cups (the supports for the stockend of the forme dampener), any up/down movement of the stock will give you this issue. If...
We had a similar issue with our handheld unit...£80 sterling for a new X-rite battery or £8.00 for an equivalent that I soldered up as per the...
Just a shot in the dark here...If it's X-rite and fitted with a rechargeable battery,it may be that the battery is sh@gg@d and won't hold charge....
Further to earlier tips...Fully oxidising inks and not just hard drying (which rely to a certain extent on penetration) would give a faster dry.
Something else occurred to me...check that the sidelay wheel itself runs free and without tight spots. I see you're Derbyshire based...we're...
Komori's sidelay, although looking a tad last century, is robust and accurate. First off I would check that the segment under the lay is set to...
Don't skimp too much - there are a few models without the PQC...steer well clear! Try DDJ Graphics... Click Me!
It's a good question William, personally I've seen many changes and not for the good. The biggest change IMO is the abundance of internet gang...
Maybe the plate supplier has a point...some inks carry coarser pigment (so they don't have to add as much maybe). We use TOYO Hy-Unity which make...