This has been resolved. I was instructed on teaching the feeder pile teaching. This taught the lower limit, and I was able to remove the slack...
We have a Rapida 142 that yesterday the feeder main pile chains counterweight activated the prox 131B1, 'pile down limitation ok.' When this prox...
The K1 relay on the board isn't holding K050 in until the press reaches 0 speed. I added a time off delay circuit to simulate K1 to hold in K252...
You are correct. I wrote that wrong.
This is correct. Normal stop is pressed and the press stops quick with a clunk sound.
We have a 2008 R702 3B P 1/1 HiPrint that blew L1 and L2 F091 fuses this morning. The fuses were replaced, and the main motor mains conductors...
If you are just buying a rebuilt hymod unit to change yours out with, then you screw out most of the fittings they ship it with and install the...
They do go bad from time to time. I generally have 2 on the shelf. When I replace one I have E&L repair the the old one. The adjustment knob and...
Hey kam, I'm on a job at the moment so I'll just spitball a bunch of things to check. If you can narrow it down from there I may be able to...
Sounds like you may have a 400B. I've uploaded a manual for them. If you have a specific question about this model I may be able to help. I have...
Thank you for this info drukman . I do know that 26/27 are side guides. In this shop side guides are generally called side registers by the sheet...
I was looking for a production date for this press but couldn't find it so I didn't post a guess. The prints are marked 2002 but I've seen some...
Both drives are now working after I was walked through how to auto reset zero position from the computer. Learned a lot today.
We've only had this press a short time (bought used) and this afternoon the operator went to set up a job and the A and B Side Registers will not...
What type is it? And what is the issue? I have a bunch of the old Hymod type units in operation and a couple of the Electronic ones also. If you...
