Thank for prompt reply, now with the error of double, when we change the format and paper size the machine dont move the rectificator, i belong...
The double sheet error diseappear when we go in inch we can pass sheet. But online error came back, and the size off paper and format Can not be...
With electronic detector
Sm52 cptronic with ZSK board
Hello friend, SM52 work in morning, afternoon start work two three sheet pass ,the double sheet sensor stop thé feeder head, and now stay...
I change the EAM and SVM board, the machine is ok now Thank you very much
Hello, i see the problem of the cptronic touch, the eam board burns.i change it, all touchs work now. But the screen of feeder and delivery dont...
Hello friend i do the initialilization of sak, i control power supply is ok. But when i remove the SAK of the machine, i see Some capacitor 5.5v...
Dear Adil, i can't access to the SAK init test because no touch on the cptronic work, we can see only the first 5 eak init test, no touch work
Hello chock, i remove and reheating RER2 and EHR2 card, the same thing, machine stop on initialization.
Dear CHOCK thank for your help, you know i control all the curent voltage, on the REE board, all voltage on REE Board is OK, I'm beginning to...
Thank chock for prompt answer, you can tell me which card i try to reheating
hello Adil, i told that the cptronic stop on initialization, i send the picture, the machine run when electrical power break down now we turn on...
Hello FRIENDS I place the new ESK card of the SM74 5 units but the machine does not start, it stops on initialization. or there is a difference...
thank you friends I used the other interface ports on the SVM. the same problem, how to proceed to see the version of the techno trans...
good evening friends, the technotrans TFK-CP10.1 of the SM74 - 4 97, after disconnecting the SVM E40-X2 connector to repair the techno trans,...
Hello friends, I have a problem with the main pile delivery of an MO 4 unit 97. the main pile delivery works for a few seconds and hangs, you...
thank you thank you friends, I reset the SAK card, and the problem is solved I remove all the wires that I connect to the machine, now it runs...
New thank you here are the variant key screenshots
thank you here are the variant key screenshots