this is exactly what happened. All good now. Thx
Press shuts down a few seconds after powering up. Has anyone encountered this issue? Which fuse should I be looking at? We can’t get an...
we have done everything mentioned above. We have used 2 different motors same result. We took the belt off to see if there was resistance on the...
It doesn’t wanna move on hand held either. Only moves about an eigth of an inch then stops. we think it’s the sensor for max sheet size because...
That is a new motor we just put in.
Yes we have done both. We swapped boards A351 slots 5 and 8. Same error. Where is the side lays motor located?
We’re having trouble changing the infeed sheet size. The motor keeps stopping even after being replaced. We have auto reset the guide. It wouldn’t...
We have figured it out thx
We had to replace a box or a board for this on a different unit before but can’t remember which one. Help will be greatly appreciated. Thx
Thanks guys. I have adjusted the switch and all works now. Much appreciated.
Ok so that’s what needs to be adjusted? I’m guessing the brakes are worn and need to be adjusted to the sensor correct?
Ok thank you very much. I will show these to our electrcian tomorrow
So to get to that micro switch I’ll have to open the motor? Or is the switch next to the tacho?
Another thing. What is this watchdog
And by any chance, does this air pressure sensor have anything to do with it? The other pressman bypassed this sensor and no longer connected.
I guess the motor needs to be taken off the press to get it opened? Sounds like a job lol.
Is that the lever on the brake or something electronic? Because when I reboot the press, the lever goes on and off and I get the fault “ The main...
Has anyone come across this problem before? I swapped out the tachometer generator with another press but same problem occurs.
As title says. Does anyone know which board causes these problems. Tried rebooting several times. No luck
I’m looking to see if there’s a part number for the bolt only.