Thanks for Everybody I had found the problem at front lay which was not responding precisely. Now machine is running good.
Good Morning Sir 1.I have cleaned and checked its output that is OK and also have changed the sensors but still having the same isuue. 2.Checked...
Good morning Sir, 1.I have cleaned the sensors,checked the output values on Amp,its getting on and off. 2.checked the digital output values on the...
I have check all the 4 sensors according to the book are working but facing the same fault as the sensors are dirty.
Hi Sir I have the problem at Komori Lithron 6 color LS 640,when sheets arrives at the headlay it gives the fault as " Register O-side,Drive Side...
Manually it works at low and high speed but on impression during production it stops. I swap this motor to other unit it works and also swap the...
Thanks for the support i check more things and tell you later sir.
There is no mother board only separate cards are there. But i have to look at contactors and relays which are on electrical side.
No it does not work shows the same behaviour as the olderone. I have also swaped the electronic boards also but got the same result.
I have exchanged but the result is same but i have to check the contactors.
No i have not looked at the potentiometer but its carbon and tacho on the top but my question is that this motor works good on other unit.
Dear sir Motor outside the roller is also not working.
Dear sir there is no fault in gearbox because this motor working good on the other unit.
Yes by dismentaling the motor outside the roller the problem is same and stop working when impression gets on.
By interchanging the motor at other unit its working good. I am surprised to see the fault that motor, board and wiring everything is working at...
Thanks sir i made the connections accurately.
Dear Sir I have SORMZ 2 color Heidelberg machine that has the problem with the dampening motor that stops running as it goes on...
Dear Sir I have the issue with main motor encoder Of the GTO 52-1 Machine. Its wires have been broken from the encoder jack. If anybody...